Precautions for using the edge banding machine

The main advantage of the curved edge banding machine is that the bonding is firm, fast, light and efficient. To achieve this effect, in addition to the good edge banding machine, you should also pay attention to the edge banding, hot melt adhesive, substrate, Elements such as work environment and method of operation. Select the edge band to pay attention to the width, thickness, material, toughness, surface treatment and other factors. Hot melt adhesives should pay attention to the difference between high, medium and low temperature adhesives, and match the types of edge banding. It is also necessary to scientifically set the temperature to control the temperature and the flowability and solidification delay of the sol. The selection of the substrate also has the requirements of mass, temperature, parallelism and perpendicularity of the cutting surface. The indoor temperature and dust concentration of the working environment also need to be considered, the speed of the substrate, the edge band, the speed of the rubber shaft, the pressure, the balance, Coherence and the like will affect the edge-sealing effect. Fourth, the method of repairing the curved edge banding machine The curved straight edge banding machine will also have some problems and failures in use. Common faults are:

1. Electrical failure. Including the host stop, the temperature is not fast, the program is disordered, etc., if not eliminated in time, it will burn the motor and the heating tube, and even damage the entire mechanical system. Mainly check the electrical control box, motor, heating tube, delay device, etc. during maintenance. This type of overhaul is usually repaired by a professional or by a manufacturer's manufacturer.

2. The gas path is faulty. Including gas valve failure, air leakage, low air pressure, cutting knife, feeding does not work, etc., mainly check the integrity of various pneumatic components, replacement parts can be carried out under the guidance of the manufacturer's technical staff.

3. Mechanical failure. There are mainly transmission failures, uneven glue coating, feeding failure and cutter failure, etc., mainly checking the integrity and firm parts of the mechanical parts, and whether the transmission parts are offset.

4, bonding failure. Such as sticking, deviation, entrainment, etc., this is a comprehensive fault, related to the rubber shaft, edge band, sol, substrate and operation. Such failures may occur alternately or in a single occurrence. Specific repairs are subject to availability.